Телефон: (011) 7541-421, 3409-301, 3409-335, 6547-293, 3409-310
E-mail: Продаја стандарда: prodaja@iss.rs Семинари, обуке: iss-edukacija@iss.rs Информације о стандардима: infocentar@iss.rs
Стевана Бракуса 2, 11030 Београд
Главни мени

ISO 2439:2008

Flexible cellular polymeric materials — Determination of hardness (indentation technique)
3. 12. 2008.

Опште информације

90.93     14. 6. 2021.

ISO

ISO/TC 45/SC 4

Међународни стандард

83.100  

енглески   француски  

Куповина

Објављен

Језик на коме желите да примите документ.

Апстракт

The indentation hardness of flexible cellular materials is a measure of their load-bearing properties. ISO 2439:2008 specifies four methods (A to D) for the determination of indentation hardness and one method (E) for determination of compressive deflection coefficient and hysteresis loss rate of flexible cellular materials. Annex A provides a summary of test parameters and typical force-indentation graphs obtained with these methods.
These five methods are applicable only to latex foam, urethane foam and PVC foam of the open-cell type. The methods specified can be used for testing finished articles and for the characterization of bulk material.
ISO 2439:2008 specifies the following methods:

Method A — Determination of the 40 %/30 s indentation hardness index, which gives a single indentation measurement for laboratory test purposes;
Method B — Determination of the 25 %-40 %-65 %/30 s indentation hardness characteristics, which provides information about the shape of the hardness indentation curve;
Method C — Determination of the 40 % indentation hardness check, which is a quick procedure suitable for quality control testing;
Method D — Determination of the 25 %/20 s low indentation hardness index, which is a quick procedure suitable as an inspection test;
Method E — Determination of the compressive deflection coefficient and hysteresis loss rate, which gives additional information about the load-bearing properties of materials.

The results obtained by these methods relate only to the test conditions specified and cannot, in general, be used directly for design purposes.

Животни циклус

ПРЕТХОДНО

ПОВУЧЕН
ISO 2439:1997

ПОВУЧЕН
ISO 2439:1997/Cor 1:1998

ТРЕНУТНО

ОБЈАВЉЕН
ISO 2439:2008
90.93 Одлука о потврђивању стандарда
14. 6. 2021.

Национална преузимања

Fleksibilni polimerni materijali sa ćelijama- Određivanje tvrdoće (metoda utiskivanja)

60.60   Стандард објављен