Proizvodi za toplotnu izolaciju zgrada — In-situ izrađeni proizvodi od nevezane mineralne vune (MW) — Deo 1: Specifikacija za proizvode od nevezanog materijala pre ugradnje - Izmena 1
Thermal insulation products for buildings - In-situ formed loose-fill mineral wool (MW) products - Part 1: Specification for the loose-fill products before installation
This document specifies the requirements for blown and injected loose-fill mineral wool products for in situ installation in lofts, masonry cavity walls and frame constructions.
This document is a specification for the insulation products before installation. It describes the product characteristics and includes procedures for testing, marking and labelling.
This document does not specify the required level of a given property to be achieved by a product to demonstrate fitness for purpose in a particular application. The levels required for a given application are to be found in regulations or non-conflicting standards.
NOTE To avoid water penetration in masonry walls special tests adjusted to local climate might be needed.
This document does not cover factory made mineral wool (MW) insulation products or in situ products intended to be used for the insulation of building equipment and industrial installations.
Products with a declared thermal resistance lower than 0,25 m2·K/W or a declared thermal conductivity greater than 0,060 W/(m·K) at 10 °C are not covered by this document.
This document does not cover products intended for airborne sound insulation and for acoustic absorption applications.
Повезане директиве
НАПОМЕНА: Уколико се у пољу са називом директиве не налази реч „хармонизован“ (обележена зеленом бојом), то значи да европски стандард није цитиран у OJEU.
