Телефон: (011) 7541-421, 3409-301, 3409-335, 6547-293, 3409-310
E-mail: Продаја стандарда: prodaja@iss.rs Семинари, обуке: iss-edukacija@iss.rs Информације о стандардима: infocentar@iss.rs
Стевана Бракуса 2, 11030 Београд
Главни мени

ISO 286-2:2010

Geometrical product specifications (GPS) — ISO code system for tolerances on linear sizes — Part 2: Tables of standard tolerance classes and limit deviations for holes and shafts
7. 6. 2010.

Опште информације

90.93     9. 6. 2021.

ISO

ISO/TC 213

Међународни стандард

17.040.10  

енглески   француски   руски  

Куповина

Објављен

Језик на коме желите да примите документ.

Апстракт

ISO 286-2:2010 gives values of the limit deviations for commonly used tolerance classes for holes and shafts calculated from the tables given in ISO 286‑1. ISO 286-2 covers values for the upper limit deviations eU, hole (for holes) and eU, shaft (for shafts) and the lower limit deviations eL, hole (for holes) and eL, shaft (for shafts).
The ISO system for tolerances on linear size provides a system of tolerances and deviations suitable for features of the following types:

cylinders;
two parallel opposite surfaces.

For simplicity, and also because of the importance of cylindrical workpieces of circular section, only these are referred to explicitly. It should be clearly understood, however, that the tolerances and deviations given in ISO 286-2 equally apply to workpieces of other than circular sections.

Животни циклус

ПРЕТХОДНО

ПОВУЧЕН
ISO 286-2:1988

ПОВУЧЕН
ISO 286-2:1988/Cor 1:2006

НАПУШТЕН
ISO 286-2:1988/DAmd 1

НАПУШТЕН
ISO 286-2:1988/DAmd 1

ТРЕНУТНО

ОБЈАВЉЕН
ISO 286-2:2010
90.93 Одлука о потврђивању стандарда
9. 6. 2021.

ИСПРАВКЕ / ИЗМЕНЕ

ОБЈАВЉЕН
ISO 286-2:2010/Cor 1:2013

Национална преузимања

Geometrijske specifikacije proizvoda (GPS) — Sistem ISO tolerancija za dužinske mere — Deo 2: Tabele standardnih stepeni tolerancija i graničnih odstupanja za otvore i vratila

60.60   Стандард објављен