ISO 286-2:2010

Geometrical product specifications (GPS) — ISO code system for tolerances on linear sizes — Part 2: Tables of standard tolerance classes and limit deviations for holes and shafts

Datum objavljivanja: 7. 6. 2010.

Опште информације

Trenutna faza: 90.93 Effective date: 9. 6. 2021.

Inicijator: ISO

Pripada: ISO/TC 213

Vrsta: Međunarodni standard

ICS: 17.040.10

Jezik: engleski francuski ruski

Kupovina

Status: Objavljen

PDF

Papir

PDF i papir

Jezik

Jezik na kome želite da primite dokument.

Apstrakt

ISO 286-2:2010 gives values of the limit deviations for commonly used tolerance classes for holes and shafts calculated from the tables given in ISO 286‑1. ISO 286-2 covers values for the upper limit deviations eU, hole (for holes) and eU, shaft (for shafts) and the lower limit deviations eL, hole (for holes) and eL, shaft (for shafts).
The ISO system for tolerances on linear size provides a system of tolerances and deviations suitable for features of the following types:

cylinders;
two parallel opposite surfaces.

For simplicity, and also because of the importance of cylindrical workpieces of circular section, only these are referred to explicitly. It should be clearly understood, however, that the tolerances and deviations given in ISO 286-2 equally apply to workpieces of other than circular sections.

Životni ciklus

PRETHODNO

POVUČEN
ISO 286-2:1988

POVUČEN
ISO 286-2:1988/Cor 1:2006

NAPUŠTEN
ISO 286-2:1988/DAmd 1

TRENUTNO

OBJAVLJEN
ISO 286-2:2010
90.93 Odluka o potvrđivanju standarda
9. 6. 2021.

ISPRAVKE / IZMENE

OBJAVLJEN
ISO 286-2:2010/Cor 1:2013

Nacionalna preuzimanja

SRPS EN ISO 286-2:2013

ISS

Geometrijske specifikacije proizvoda (GPS) — Sistem ISO tolerancija za dužinske mere — Deo 2: Tabele standardnih stepeni tolerancija i graničnih odstupanja za otvore i vratila

60.60 Standard objavljen

M010 Saznaj više