Phone: (011) 7541-421, 3409-301, 3409-335, 6547-293, 3409-310
E-mail: Standards sales: prodaja@iss.rs Education: iss-edukacija@iss.rs Information about standards: infocentar@iss.rs
Stevana Brakusa 2, 11030 Beograd
Main menu

SRPS B.H8.131:2015

Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity)

Oct 30, 2015

General information

60.60     Oct 30, 2015

ISS

B028-2

17.060     75.080  

English  

van plana 2015.

Buying

Published

Language in which you want to receive the document.

Scope

This test method specifies a procedure for the determination of the kinematic viscosity, ν, of liquid petroleum products, both transparent and opaque, by measuring the time for a volume of liquid to flow under gravity through a calibrated glass capillary viscometer. The dynamic viscosity, η, can be obtained by multiplying the kinematic viscosity, ν, by the density, ρ, of the liquid.
NOTE 1: For the measurement of the kinematic viscosity and viscosity of bitumens, see also Test Methods D2170 and D2171.
NOTE 2: ISO 3104 corresponds to Test Method D445 – 03.
The result obtained from this test method is dependent upon the behavior of the sample and is intended for application to liquids for which primarily the shear stress and shear rates are proportional (Newtonian flow behavior). If, however, the viscosity varies significantly with the rate of shear, different results may be obtained from viscometers of different capillary diameters. The procedure and precision values for residual fuel oils, which under some conditions exhibit non-Newtonian behavior, have been included.
The range of kinematic viscosities covered by this test method is from 0.2 mm2/s to 300 000 mm2/s (see Table A1.1) at all temperatures (see 6.3 and 6.4). The precision has only been determined for those materials, kinematic viscosity ranges and temperatures as shown in the footnotes to the precision section.
The values stated in SI units are to be regarded as standard. The SI unit used in this test method for kinematic viscosity is mm2/s, and the SI unit used in this test method for dynamic viscosity is mPa•s. For user reference, 1 mm2/s = 10-6 m2/s = 1 cSt and 1 mPa•s = 1 cP = 0.001 Pa•s.

Life cycle

PREVIOUSLY

WITHDRAWN
SRPS B.H8.131:2015

NOW

PUBLISHED
SRPS B.H8.131:2015
60.60 Standard published
Oct 30, 2015

REVISED BY

PROJECT
prSRPS B.H8.131:2024

Related project

Adopted from ASTM D445-15

Regulation

PRAVILNIK o izmenama i dopunama Pravilnika o tehničkim i drugim zahtevima za tečna goriva naftnog porekla

МИНИСТАРСТВО РУДАРСТВА И ЕНЕРГЕТИКЕ