Projects

Terrestrial photovoltaic (PV) modules - Design qualification and type approval - Part 1-3: Special requirements for testing of thin-film amorphous silicon based photovoltaic (PV) modules

10.99   New project approved

Terrestrial photovoltaic (PV) modules - Design qualification and type approval - Part 1-4: Special requirements for testing of thin-film cu(In,GA)(S,Se)2 based photovoltaic (PV) modules

10.99   New project approved

Terrestrial photovoltaic (PV) modules - Design qualification and type approval - Part 1: Test requirements

10.99   New project approved

Terrestrial photovoltaic (PV) modules - Design qualification and type approval - Part 2: Test procedures

10.99   New project approved

Compression and mechanical connectors for power cables - Part 1-1: Test methods and requirements for compression and mechanical connectors for power cables for rated voltages up to 1 kv (Um = 1,2 kV) tested on non-insulated conductors

10.99   New project approved

Compression and mechanical connectors for power cables - Part 1-2: Test methods and requirements for insulation piercing connectors for power cables for rated voltages up to 1 kv (Um = 1,2 kV) tested on insulated conductors

10.99   New project approved

Compression and mechanical connectors for power cables - Part 1-3: Test methods and requirements for compression and mechanical connectors for power cables for rated voltages above 1 kv (Um = 1,2 kV) up to 30 kv (Um = 36 kV) tested on non-insulated conductors

10.99   New project approved

Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 3-35: Examinations and measurements - Visual inspection of fibre optic connectors and fibre-stub transceivers

10.99   New project approved

Industrial cable reels

10.99   New project approved

Electrical equipment for measurement, control and laboratory use - EMC requirements - Part 2-6: Particular requirements - In vitro diagnostic (IVD) medical equipment

10.99   New project approved

Wind energy generation systems - Part 3-2: Design requirements for floating offshore wind turbines

10.99   New project approved

Composite hollow insulators - Pressurized and unpressurized insulators for use in electrical equipment with AC rated voltage greater than 1 000 v AC and d.c. voltage greater than 1500v - Definitions, test methods, acceptance criteria and design recommendations

10.99   New project approved

Installation couplers intended for permanent connection in fixed installations

10.99   New project approved

Installation couplers intended for permanent connection in fixed installations

10.99   New project approved

Installation couplers intended for permanent connection in fixed installations

10.99   New project approved

Fibre optic interconnecting devices and passive components - Performance standard - Part 021-02: Single-mode fibre optic connectors terminated as pigtails and patchcords for category c - Controlled environment

10.99   New project approved

Fibre optic interconnecting devices and passive components - Performance standard - Part 021-06: Single-mode fibre optic connectors terminated as pigtails and patchcords for category OP+ - Extended outdoor protected environment

10.99   New project approved

Industrial networks - Profiles - Part 2-13: Additional real-time fieldbus profiles based on ISO/IEC/IEEE 8802-3 - CPF 13

10.99   New project approved