Projects

Chemical analysis of refractory products by X-ray fluorescence (XRF) — Fused cast-bead method

90.93   Standard confirmed

Refractory products — Measurement of dimensions and external defects of refractory bricks — Part 1: Dimensions and conformity to drawings

90.93   Standard confirmed

Refractory products — Measurement of dimensions and external defects of refractory bricks — Part 2: Corner and edge defects and other surface imperfections

90.93   Standard confirmed

Thermal spraying — Recommendations for thermal spraying

90.93   Standard confirmed

Fibre-reinforced plastics — Methods of producing test plates — Part 1: General conditions

90.93   Standard confirmed

Fibre-reinforced plastics — Methods of producing test plates — Part 10: Injection moulding of BMC and other long-fibre moulding compounds — General principles and moulding of multipurpose test specimens

90.93   Standard confirmed

Fibre-reinforced plastics — Methods of producing test plates — Part 11: Injection moulding of BMC and other long-fibre moulding compounds — Small plates

90.93   Standard confirmed

Fibre-reinforced plastics — Methods of producing test plates — Part 2: Contact and spray-up moulding

90.93   Standard confirmed

Fibre-reinforced plastics — Methods of producing test plates — Part 3: Wet compression moulding

90.93   Standard confirmed

Fibre-reinforced plastics — Methods of producing test plates — Part 4: Moulding of prepregs

90.93   Standard confirmed

Fibre-reinforced plastics — Methods of producing test plates — Part 4: Moulding of prepregs — Amendment 1

60.60   Standard published

Fibre-reinforced plastics — Methods of producing test plates — Part 5: Filament winding

90.93   Standard confirmed

Fibre-reinforced plastics — Methods of producing test plates — Part 6: Pultrusion moulding

90.93   Standard confirmed

Fibre-reinforced plastics — Methods of producing test plates — Part 7: Resin transfer moulding

90.93   Standard confirmed

Fibre-reinforced plastics — Methods of producing test plates — Part 8: Compression moulding of SMC and BMC

90.92   Standard to be revised

Fibre-reinforced plastics — Methods of producing test plates — Part 9: Moulding of GMT/STC

90.93   Standard confirmed

Methods of test for refractory products — Part 1: Determination of dynamic Young's modulus (MOE) by impulse excitation of vibration

90.93   Standard confirmed

Mechanically deposited coatings of zinc — Specification and test methods

90.20   Standard under periodical review