Projects

Ground thread taps for ISO metric threads of tolerances 4H to 8H and 4G to 6G coarse and fine pitches — Manufacturing tolerances on the threaded portion

90.93   Standard confirmed

Ground thread taps for ISO metric threads of tolerances 4H to 8H and 4G to 6G coarse and fine pitches — Manufacturing tolerances on the threaded portion — Amendment 1

60.60   Standard published

Ground thread taps for ISO metric threads of tolerances 4H to 8H and 4G to 6G coarse and fine pitches — Manufacturing tolerances on the threaded portion — Amendment 2

60.60   Standard published

Ground thread taps for ISO metric threads of tolerances 4H to 8H and 4G to 6G coarse and fine pitches — Manufacturing tolerances on the threaded portion — Technical Corrigendum 1

60.60   Standard published

End-suction centrifugal pumps (rating 16 bar) — Designation, nominal duty point and dimensions

90.60   Close of review

Passenger car, truck and bus tyre rolling resistance measurement method — Single point test and correlation of measurement results

90.92   Standard to be revised

Water quality — Determination of selected non-polar substances — Method using gas chromatography with mass spectrometric detection (GC-MS)

90.93   Standard confirmed

Sampling procedures for inspection by attributes — Part 1: Sampling schemes indexed by acceptance quality limit (AQL) for lot-by-lot inspection

60.60   Standard published

Sampling procedures for inspection by attributes — Part 2: Sampling plans indexed by limiting quality (LQ) for isolated lot inspection

90.60   Close of review

Sampling procedures for inspection by attributes — Part 3: Skip-lot sampling procedures

90.93   Standard confirmed

Sampling procedures for inspection by attributes — Part 4: Procedures for assessment of declared quality levels

90.60   Close of review

Sampling procedures for inspection by attributes — Part 5: System of sequential sampling plans indexed by acceptance quality limit (AQL) for lot-by-lot inspection

90.60   Close of review

Sampling procedures for inspection by attributes — Introduction to the ISO 2859 series of standards for sampling for inspection by attributes

90.93   Standard confirmed

Sequential sampling plans for inspection by attributes

90.93   Standard confirmed

Double sampling plans by attributes with minimal sample sizes, indexed by producer's risk quality (PRQ) and consumer's risk quality (CRQ)

90.93   Standard confirmed

Acceptance sampling procedures by attributes — Accept-zero sampling system based on credit principle for controlling outgoing quality

90.93   Standard confirmed

Combined accept-zero sampling systems and process control procedures for product acceptance

90.93   Standard confirmed

Sampling procedures for inspection by attributes — Two-stage sampling plans for auditing and for inspection under prior information

60.60   Standard published