Phone: (011) 7541-421, 3409-301, 3409-335, 6547-293, 3409-310
E-mail: Standards sales: prodaja@iss.rs Education: iss-edukacija@iss.rs Information about standards: infocentar@iss.rs Certification body: sertifikaciono.telo@iss.rs
Stevana Brakusa 2, 11030 Beograd
Main menu

ISO 4437-2:2024

Plastics piping systems for the supply of gaseous fuels — Polyethylene (PE) — Part 2: Pipes

Feb 14, 2024
95.99   Withdrawal of Standard   Oct 14, 2026

General information

95.99     Oct 14, 2026

ISO

ISO/TC 138/SC 4

International Standard

83.140.30     75.200  

English  

Buying

Withdrawn

Language in which you want to receive the document.

Scope

This document specifies the characteristics of pipes made from polyethylene (PE) for piping systems in the field of the supply of gaseous fuels.
It also specifies the test parameters for the test methods referred to in this document.
In conjunction with ISO 4437-1, ISO 4437-3, ISO 4437-4 and ISO 4437-5, this document is applicable to PE pipes, fittings and valves, their joints, and joints with components of PE and other materials intended to be used under the following conditions:
a)       a maximum operating pressure (MOP), up to and including 10 bar[1], at a reference temperature of 20 °C for design purposes;
b)       an operating temperature between −20 °C and 40 °C.
For operating temperatures between 20 °C and 40 °C, derating coefficients are defined in ISO 4437-5.
The ISO 4437 series covers a range of MOPs and gives requirements concerning colours.
This document is applicable to three types of pipes:
—     PE pipes (outside diameter, dn) including any identification stripes;
—     PE pipes with co-extruded layers on either or both the outside and/or inside of the pipe (total outside diameter, dn) as specified in Annex A, where all PE layers have the same MRS rating;
—     PE pipes (outside diameter, dn) with a peelable and contiguous thermoplastics additional layer on the outside of the pipe ("coated pipe") as specified in Annex B.
It is the responsibility of the purchaser or specifier to make the appropriate selections from these aspects, taking into account their particular requirements and any relevant national regulations and installation practices or codes.


[1]  1 bar = 0,1 MPa = 105 Pa; 1 MPa = 1 N/mm2.

Life cycle

PREVIOUSLY

WITHDRAWN
ISO 4437-2:2014

NOW

WITHDRAWN
ISO 4437-2:2024
95.99 Withdrawal of Standard
Oct 14, 2026

REVISED BY

PUBLISHED
ISO 4437-2:2026