SRPS EN 1218-1:2011

Safety of woodworking machines - Tenoning machines - Part 1: Single end tenoning machines with sliding table

Scope

This document specifies all the significant hazards, hazardous situations and events as listed in Clause 4 which are relevant to single end tenoning machines with sliding table, hereinafter referred to as "machines", designed to cut solid wood, chipboard, fibreboard, plywood and also these materials where they are covered with plastic laminate or edgings.
This standard does not apply to:
a) machines where the tenon is produced only by means of saw blades;
b) machines where the design speed of any tool spindle exceeds 6000 min-1;
c) machines where the average sliding table feed speed in either direction exceeds 25 m min-1 + 5%;
d) combined machines used for tenoning (see EN 940:1997);
e) tenoning attachments on a vertical spindle moulding machine (see EN 848-1:2007).
NOTE Single and double end tenoning machines fed by chain or chains are dealt with in EN 1218-2. Single end tenoning machines where the tenon is produced only by means of saw blades are dealt with in EN 1218-3.
This European Standard is primarily applicable to machines which are manufactured after the date of issue of his standard.

Related directives

NOTE: If the word "harmonized" (marked in green) is not found in the field with the name of the directive, it means that the European standard is not cited in the OJEU.

National regulations and standards