SRPS CLC/TS 50217:2012

Guide for in situ measurements - In situ measurement of disturbance emission

Scope

This guide describes analysis methods of disturbance emission to be applied in situ for identification of the disturbance source and resolution of complaint. Where applicable, the methods rely on already published documents either in CENELEC or in IEC. It is not intended to be used for type testing or any kind of conformity assessment. Dealing with effects on living matter is excluded from this document. The frequency range of interest is from d.c. to 400 GHz. This document applies for analysing an interference complaint. It provides method for identification and characterisation in situ of the source(s) of interference. It proposes procedures to discriminate different kind of sources. Reference in situ measurement distances are defined. It allows comparison of the results and of technical characteristics of the interfered equipment with existing relevant standards. The result of the comparison is intended to help in the resolution of the complaint. It is meant for verifying the emissions from fixed installations whatever equipment they contain, and whatever have been the type tests of these equipment. It may be used to describe the coupling path for interference between the victim and the source, and to compare the measurement results with the limits from the adequate standard, at a specific location and in a given frequency band.

Related directives

NOTE: If the word "harmonized" (marked in green) is not found in the field with the name of the directive, it means that the European standard is not cited in the OJEU.