SRPS EN IEC 61347-2-13:2025

Controlgear for electric light sources - Safety - Part 2-13: Particular requirements - Electronic controlgear for LED light sources

Scope

IEC 61347-2-13:2024 specifies safety requirements for electronic controlgear for LED light sources for use on DC supplies up to 1 500 V or on AC supplies up to 1 000 V at 50 Hz or 60 Hz.

This document is applicable for electronic controlgear for LED light sources with an output voltage (RMS) not higher than 1 000 V.

This third edition cancels and replaces the second edition published in 2014 and Amendment 1:2016. This edition constitutes a technical revision.

This edition includes the following significant technical changes with respect to the previous edition:

a) alignment with respect to the fourth edition of IEC 61347-1:

- introduction of dated references to the fourth edition of IEC 61347-1 as appropriate;

- deletion of the clauses and subclauses which are either no longer relevant or now covered in IEC 61347-1;

b) update of normative references, introducing dated references where appropriate;

c) scope extension to 1 500 V for direct current;

d) scope clarification;

e) deletion of unused definitions;

f) revision of information and marking requirements;

g) new marking requirement "electronic controlgear for LED light sources";

h) new requirements for electronic controlgear for LED light sources with constant light output function or programmable current (additions to Clause 3, Clause 6, Clause 16 and Clause 18);

i) modification of requirements for the determination of the output working voltage (new Clause 17);

j) new requirements for the determination of the rated output characteristics (Clause 18).

Related directives

NOTE: If the word "harmonized" (marked in green) is not found in the field with the name of the directive, it means that the European standard is not cited in the OJEU.