Projects

Packaging of components for automatic handling - Part 5: Matrix trays

60.60   Standard published

Packaging of components for automatic handling - Part 6: Bulk case packaging for surface mounting components

60.60   Standard published

Electric cables - Calculation of the current rating - Part 1-1: Current rating equations (100 % load factor) and calculation of losses - General

60.60   Standard published

Electric cables - Calculation of the current rating - Part 1-2: Current rating equations (100 % load factor) and calculations of losses - Sheath eddy current loss factors for two circuits in flat formation

60.60   Standard published

Electric cables - Calculation of the current rating - Part 1-3: Current rating equations (100 % load factor) and calculation of losses - Current sharing between parallel single-core cables and calculation of circulating current losses

60.60   Standard published

Electric cables - Calculation of the current rating - Part 2-1: Thermal resistance - Calculation of thermal resistance

60.60   Standard published

Electric cables - Calculation of the current rating - Part 2: Thermal resistance - Section 2: A method for calculating reduction factors for groups of cables in free air, protected from solar radiation

60.60   Standard published

Electric cables - Calculation of the current rating - Part 3-1: Operating conditions - Site reference conditions

60.60   Standard published

Electric cables - Calculation of the current rating - Part 3-2: Sections on operating conditions - Economic optimization of power cable size

60.60   Standard published

Aerospace series - Rod-ends, adjustable, single fork with UNJ threaded shank min. engagement: 1,5 x thread diameter in corrosion resisting steel - Dimensions and loads - Inch series

60.60   Standard published

Measurement of the dimensions of a cylindrical component with axial terminations

90.93   Standard confirmed

Fluids for electrotechnical applications - Mineral insulating oils for electrical equipment

60.60   Standard published

Mechanical structures for electronic equipment - Dimensions of mechanical structures of the 482,6 mm (19 in) series - Part 3-100: Basic dimensions of front panels, subracks, chassis, racks and cabinets

60.60   Standard published

Mechanical structures for electronic equipment - Dimensions of mechanical structures of the 482,6 mm (19 in) series - Part 3-101: Subracks and associated plug-in units

90.93   Standard confirmed

Mechanical structures for electronic equipment - Dimensions of mechanical structures of the 482,6 mm (19 in) series - Part 3-102: Injector/extractor handle

90.93   Standard confirmed

Mechanical structures for electronic equipment - Dimensions of mechanical structures of the 482,6 mm (19 in) series - Part 3-103: Keying and alignment pin

90.93   Standard confirmed

Mechanical structures for electronic equipment - Dimensions of mechanical structures of the 482,6 mm (19 in) series - Part 3-104: Connector dependent interface dimensions of subracks and plug-in units

60.60   Standard published

Mechanical structures for electronic equipment - Dimensions of mechanical structures of the 482,6 mm (19 in) series - Part 3-105: Dimensions and design aspects for 1U high chassis

60.60   Standard published