Projects

Public information guidance systems — Part 1: Design principles and element requirements for location plans, maps and diagrams

60.60   Standard published

Public information guidance systems — Part 2: Guidelines for the design and use of location signs and direction signs

90.93   Standard confirmed

Public information guidance systems — Part 3: Guidelines for the design and use of information index signs

90.92   Standard to be revised

Public information guidance systems — Part 4: Installation and assessment

60.60   Standard published

Ground thread taps for ISO metric threads of tolerances 4H to 8H and 4G to 6G coarse and fine pitches — Manufacturing tolerances on the threaded portion

90.93   Standard confirmed

Ground thread taps for ISO metric threads of tolerances 4H to 8H and 4G to 6G coarse and fine pitches — Manufacturing tolerances on the threaded portion — Amendment 1

60.60   Standard published

Ground thread taps for ISO metric threads of tolerances 4H to 8H and 4G to 6G coarse and fine pitches — Manufacturing tolerances on the threaded portion — Amendment 2

60.60   Standard published

Ground thread taps for ISO metric threads of tolerances 4H to 8H and 4G to 6G coarse and fine pitches — Manufacturing tolerances on the threaded portion — Technical Corrigendum 1

60.60   Standard published

End-suction centrifugal pumps (rating 16 bar) — Designation, nominal duty point and dimensions

90.60   Close of review

Passenger car, truck and bus tyre rolling resistance measurement methods — Single point test and correlation of measurement results

60.60   Standard published

Water quality — Determination of selected non-polar substances — Method using gas chromatography with mass spectrometric detection (GC-MS)

90.93   Standard confirmed

Sampling procedures for inspection by attributes — Part 1: Sampling schemes indexed by acceptance quality limit (AQL) for lot-by-lot inspection

60.60   Standard published

Sampling procedures for inspection by attributes — Part 2: Sampling plans indexed by limiting quality (LQ) for isolated lot inspection

90.60   Close of review

Sampling procedures for inspection by attributes — Part 3: Skip-lot sampling procedures

90.93   Standard confirmed

Sampling procedures for inspection by attributes — Part 4: Procedures for assessment of declared quality levels

90.60   Close of review

Sampling procedures for inspection by attributes — Part 5: System of sequential sampling plans indexed by acceptance quality limit (AQL) for lot-by-lot inspection

90.60   Close of review

Sampling procedures for inspection by attributes — Introduction to the ISO 2859 series of standards for sampling for inspection by attributes

90.93   Standard confirmed

Sequential sampling plans for inspection by attributes

90.93   Standard confirmed