ISO 4759-3:2016

Tolerances for fasteners — Part 3: Washers for bolts, screws and nuts — Product grades A, C and F

Datum objavljivanja: 1. 6. 2016.

Опште информације

Trenutna faza: 90.93 Effective date: 28. 6. 2021.

Inicijator: ISO

Pripada: ISO/TC 2

Vrsta: Međunarodni standard

ICS: 21.060.30

Jezik: engleski francuski

Kupovina

Status: Objavljen

PDF

Papir

PDF i papir

Jezik

Jezik na kome želite da primite dokument.

Apstrakt

ISO 4759-3:2016 specifies tolerances for flat washers of product grades A, C and F with nominal diameters of 1 mm to 150 mm inclusive, designed to be used in bolted joints in combination with bolts, screws, studs and nuts.
This part of ISO 4759 may be applied to non-flat washers however it does not include all the tolerances related to these washers.
It applies to non-captive and captive washers, and to standard and non-standard washers.
It does not apply to dynamic disc springs.
Washers of product grades F and A are intended to be used with bolts, screws, studs and nuts of product grades A and B; washers of product grade C are intended to be used with bolts, screws, studs and nuts of product grade C.
NOTE The product grade refers to a specific tolerance range related to dimensional and geometrical characteristics (product grade F for fine tolerances, product grade A for precise tolerances, product grade C for large tolerances).
Annex A presents tolerances taken from ISO 286‑1 and ISO 286‑2.

Životni ciklus

PRETHODNO

POVUČEN
ISO 4759-3:2000

TRENUTNO

OBJAVLJEN
ISO 4759-3:2016
90.93 Odluka o potvrđivanju standarda
28. 6. 2021.

Nacionalna preuzimanja

SRPS EN ISO 4759-3:2017

ISS

Tolerancije delova za pričvršćivanje – Deo 3: Ravne podloške za vijke i navrtke – Klase izrade A, C i F

60.60 Standard objavljen

M010 Saznaj više