ISO 20486:2017

Non-destructive testing — Leak testing — Calibration of reference leaks for gases

Datum objavljivanja: 14. 12. 2017.

Опште информације

Trenutna faza: 90.60 Effective date: 5. 3. 2023.

Inicijator: ISO

Pripada: ISO/TC 135/SC 6

Vrsta: Međunarodni standard

ICS: 19.100

Jezik: engleski francuski

Kupovina

Status: Objavljen

PDF

Papir

PDF i papir

Jezik

Jezik na kome želite da primite dokument.

Apstrakt

ISO 20486:2017 specifies the calibration of those leaks that are used for the adjustment of leak detectors for the determination of leakage rate in everyday use. One type of calibration method is a comparison with a reference leak. In this way, the leaks used for routine use become traceable to a primary standard. In other calibration methods, the value of vapour pressure was measured directly or calculated over a known volume.
The comparison procedures are preferably applicable to helium leaks, because this test gas can be selectively measured by a mass spectrometer leak detector (MSLD) (the definition of MSLD is given in ISO 20484).
Calibration by comparison (see methods A, As, B and Bs below) with known reference leaks is easily possible for leaks with reservoir and leakage rates below 10−7 Pa·m3/s.
Figure 1 gives an overview of the different recommended calibration methods.

Životni ciklus

TRENUTNO

OBJAVLJEN
ISO 20486:2017
90.60 Završetak postupka preispitivanja standarda
5. 3. 2023.

Nacionalna preuzimanja

SRPS EN ISO 20486:2018

ISS

Ispitivanje bez razaranja – Ispitivanje propusnosti – Kalibracija referentnih propusnosti gasova

60.60 Standard objavljen

C135 Saznaj više