Projekti

Electronic imaging — Recommendations for the management of electronic recording systems for the recording of documents that may be required as evidence, on WORM optical disk

90.93   Odluka o potvrđivanju standarda

Energy performance of buildings — Presentation of measured energy use of buildings

90.93   Odluka o potvrđivanju standarda

Micrographics — Use of bar codes on aperture cards

90.93   Odluka o potvrđivanju standarda

Commercial vehicles and buses — Cross-tooth propeller shaft flanges, type T

90.93   Odluka o potvrđivanju standarda

Hydraulic fluid power — Method for determining the required cleanliness level (RCL) of a system

90.93   Odluka o potvrđivanju standarda

Thermal spraying — Components with thermally sprayed coatings — Technical supply conditions

90.93   Odluka o potvrđivanju standarda

Thermal spraying — Thermally sprayed coatings — Symbolic representation on drawings

90.60   Završetak postupka preispitivanja standarda

Refractory products — Determination of resistance to carbon monoxide

90.93   Odluka o potvrđivanju standarda

Chemical analysis of refractory products by X-ray fluorescence (XRF) — Fused cast-bead method

90.93   Odluka o potvrđivanju standarda

Refractory products — Measurement of dimensions and external defects of refractory bricks — Part 1: Dimensions and conformity to drawings

90.93   Odluka o potvrđivanju standarda

Refractory products — Measurement of dimensions and external defects of refractory bricks — Part 2: Corner and edge defects and other surface imperfections

90.93   Odluka o potvrđivanju standarda

Thermal spraying — Recommendations for thermal spraying

90.93   Odluka o potvrđivanju standarda

Fibre-reinforced plastics — Methods of producing test plates — Part 1: General conditions

90.93   Odluka o potvrđivanju standarda

Fibre-reinforced plastics — Methods of producing test plates — Part 10: Injection moulding of BMC and other long-fibre moulding compounds — General principles and moulding of multipurpose test specimens

90.93   Odluka o potvrđivanju standarda

Fibre-reinforced plastics — Methods of producing test plates — Part 11: Injection moulding of BMC and other long-fibre moulding compounds — Small plates

90.93   Odluka o potvrđivanju standarda

Fibre-reinforced plastics — Methods of producing test plates — Part 2: Contact and spray-up moulding

90.93   Odluka o potvrđivanju standarda

Fibre-reinforced plastics — Methods of producing test plates — Part 3: Wet compression moulding

90.93   Odluka o potvrđivanju standarda

Fibre-reinforced plastics — Methods of producing test plates — Part 4: Moulding of prepregs

90.93   Odluka o potvrđivanju standarda